GEN 3 settings

Discussion in 'TFI Questions Answered By Dobeck' started by sprinklerfitter669, Oct 5, 2010.

  1. sprinklerfitter669

    sprinklerfitter669 Junior Member

    982
    0
    6
    Getting ready this weekend to install my Gen3, however i cannot find the settings?
    Ifound them for the TFI?

    I got stage 1 download, AC, and i am getting rid of the Cat by installing a set of 2009 headpipes, and rush slip ons?

    Anybody know where to look?
     
  2. BUBBIE

    BUBBIE Well-Known Member

    4,959
    83
    113
    ---------------------------------------------------------------
    Call Dobecks....

    I think the gen 3 comes set to the suggested settings for your bike???

    Let us know and or ASK under TFI product support and the answer will be there for all to see..

    signed....BUBBIE

    You are going to like that bike More ,,,,,, a LOT MORE after install
     
  3. Iceman24

    Iceman24 Well-Known Member

    3,224
    48
    13
    sprinklerfitter; Dobeck has an area on the forum for questions/answers - try posting in this section & they should reply. Also, my TFI came w/instructions (GEN2) so I'll assume yours will too??? Either way - contact Dobeck & they've got awesome Customer Service. Good luck w/the install & you'll like the after-install difference...prepare to be amazed on how much better your bike runs w/proper adjustment(s).
     
  4. sprinklerfitter669

    sprinklerfitter669 Junior Member

    982
    0
    6
    Thanks Guys,
    forgot about the doebeck section on the forum. I will repost there.

    Iceman, i did get instructions for install, just not settings
     
  5. DobeckTechSupport

    DobeckTechSupport Active Member Product Contributor

    149
    28
    2
    GEN 3 controllers come preset for typical stage 1 modifications. The recommended settings to start with are already in the controller. They are also listed on the ElectronicJetKit.com website.
     
  6. sprinklerfitter669

    sprinklerfitter669 Junior Member

    982
    0
    6
    As always thank you Dobeck for being there for great support :D
     
  7. sprinklerfitter669

    sprinklerfitter669 Junior Member

    982
    0
    6
    installed Gen3 yesterday. wnet for a ride and ran great. seemed to have a little more get up and go.
    My only concern is when i stopped at a traffic light, the bike was idling, then it went a little lower. Do i need to adjust it?
    I only installed, and did not change any settings

    2010 RK CAT removed, SE stage 1, Rush slip ons
     
  8. i8mich

    i8mich Member

    17
    11
    0
    sprinkleritter669 can I ask what size baffles you have for the rush slip ons ? and also can you post what your gen 3 came preset at...Thanks'