Engine light?

Discussion in 'General Harley Davidson Topic' started by OMJ1, Jun 13, 2007.

  1. OMJ1

    OMJ1 New Member

    3
    11
    0
    I have 1999 Road King and the engine light keeps flashing 3 times in a row.
    It does this continually, thing is I changed the ignition modul to a Crane TC-4 along
    time ago, and until this year I have never had this happen? Any advice?

    Thanks ahead of time
     
  2. XL1200N

    XL1200N Frozen Account

    136
    26
    0
    Appears the bike needs a diagnostic. Those type of flashing sequences usually have a code attached to them.:57:
     
  3. glider

    glider Veteran Member

    25,464
    108
    44
    Try this sequence and see what the code is, it may not work properly with the different module but worth a try.

    1. Remove right side saddlebag and side cover if so equipped. Remove protective plug from data link connector.

    2. To activate the diagnostic feature, proceed as follows:
    a. Create diagnostic test wire or use a female spade clip.
    b. Install diagnostic test wire across Terminals 1 and 2 on the data link connector.
    c. Turn Ignition/Light Key Switch to IGNITION and wait approximately 10 seconds (4 seconds lamp ON, 6 seconds lamp OFF) for check engine lamp to start flashing.

    3. All trouble codes are sent out as a series of flashes. To retrieve the first digit of the trouble code simply observe the number of times the lamp flashes.
    a. The lamp will then flash one or more times to indicate the first digit of the trouble code.

    b. The length of time the lamp is illuminated and the length of time in which it is off are each about 0.5 second in duration.

    4. The second digit follows:
    a. Following the transmission of the first digit, there is a 1.2 second pause in which the lamp is off.
    b. The lamp will then flash one or more times to indicate the second digit of the trouble code. Count the number of times the lamp flashes to retrieve the second digit.

    5. If more than one trouble code is sent:
    a. Following transmission of the second digit of the first code, there is a 3 second pause in which the lamp is off.
    b. Once all codes have been sent, the data string is repeated. When you have recorded the same trouble code twice, it is an indication that the transmission has been restarted and that all trouble codes have been retrieved.

    IMPORTANT NOTE ..If diagnostic test wire is installed across Pins 1 and 2 on connector in lieu of a Scanalyzer, the ECM is placed in a diagnostic test mode and the engine will start. The test wire must be removed from the data connector and the ignition switch turned OFF or the check engine lamp will continue to flash codes. A historic trouble code resides in the memory of the ECM until the code is cleared by use of the Scanalyzer or a total of 50 trips has elapsed. A “trip” consists of a start and run cycle, the run cycle lasting at least 30 seconds. After the 50 trip retention period, the trouble code is automatically erased from memory (that is, assuming no subsequent faults of the same type are detected in that period). The numbers after the 'historic' or 'current' is the speedo code number, but without the electrical diognostics manual you're peeing into the wind.

    1 Current 53 ECM flash error
    2 Historic 53 ECM flash error
    3 Current 54 ECM EEPROM error
    4 Historic 54 ECM EEPROM error
    5 Current 63 ECM serial data low
    6 Current 63 ECM serial data open/high
    7 Current 63 TSSM serial data low
    8 Current 63 TSSM serial data open/high
    9 Current 61 Loss of TSM/TSSM serial data
    10 Current 14 Loss of all ECM serial data (state of health)
    10 24 Loss of vehicle speed
    10 33 Loss of vehicle inhibit motion
    10 43 Loss of power train security status
    11 Current 33 System relay contacts open
    12 Current 33 System relay coil high/shorted
    13 Current 33 System relay coil open/low
    14 Current 33 System relay contacts closed
    15 Current 99 Incorrect password
    16 Current 99 Missing password
    17 Current 41 CKP sensor intermittent
    18 Current 41 CKP sensor synch error
    19 Current 11 TP sensor open/low
    20 Current 11 TP sensor high
    21 Current 12 MAP sensor open/low
    22 Current 12 MAP sensor high
    23 Current 14 ET sensor voltage low
    24 Current 14 ET sensor open/high
    25 Current 15 IAT sensor voltage low
    26 Current 15 IAT sensor open/high
    27 Current 24 Front ignition coil open/low
    28 Current 25 Rear ignition coil open/low
    29 Current 24 Front ignition coil high/shorted
    30 Current 25 Rear ignition coil high/shorted
    31 Current 24 Front cylinder combustion intermittent
    32 Current 25 Rear cylinder combustion intermittent
    33 Current 23 Front injector open/low
    34 Current 32 Rear injector open/low
    35 Current 23 Front injector high
    36 Current 32 Rear injector high
    37 Current 16 Battery voltage low
    38 Current 16 Battery voltage high
    39 Current 43 VSS sensor low
    40 Current 43 VSS sensor high
    41 Current N/A (no speedo code for this) Check engine light open/low NO CHECK ENGINE LAMP AT KEY ON or CHECK ENGINE LAMP ON CONTINUOUSLY
    42 Current N/A (no speedo code for this) Check engine light high NO CHECK ENGINE LAMP AT KEY ON
    43 Current 35 Tachometer low
    44 Current 35 Tachometer high
    45 Current 25 Rear cylinder no combustion
    46 Current 24 Front cylinder no combustion
    47 Current 34 Loss of idle speed control IDLE AIR CONTROL
    48 Current 35 Accelerometer fault
    49 Current 34 Starter output high
    50 Current 25 Ignition enable output high
    51 Current 21 Left turn output fault
    52 Current 22 Right turn output fault
    53 Current 11 Battery voltage high
    54 Current 31 Alarm output low
    55 Current 32 Alarm output high
    56 Current 41 Ignition switch open/low
    57 Historic 63 ECM serial data low
    58 Historic 63 ECM serial data open/high
    59 Historic 63 TSSM serial data low
    60 Historic 63 TSSM serial data open/high
    61 Historic 61 Loss of TSM/TSSM serial data
    62 Historic 14 Loss of all ECM serial data (state of health)
    63 Historic 33 System relay contacts open
    64 Historic 33 System relay coil high/shorted
    65 Historic 33 System relay coil open/low
    66 Historic 33 System relay contacts closed
    67 Historic 99 Incorrect password
    68 Historic 99 Missing password
    69 Historic 41 CKP sensor intermittent
    70 Historic 41 CKP sensor synch error
    71 Historic 11 TP sensor open/low
    72 Historic 11 TP sensor high
    73 Historic 12 MAP sensor open/low
    74 Historic 12 MAP sensor high
    75 Historic 14 ET sensor voltage low
    76 Historic 14 ET sensor open/high
    77 Historic 15 IAT sensor voltage low
    78 Historic 15 IAT sensor open/high
    79 Historic 24 Front ignition coil open/low
    80 Historic 25 Rear ignition coil open/low
    81 Historic 24 Front ignition coil high/shorted
    82 Historic 25 Rear ignition coil high/shorted
    83 Historic 24 Front cylinder combustion intermittent
    84 Historic 25 Rear cylinder combustion intermittent
    85 Historic 23 Front injector open/low
    86 Historic 32 Rear injector open/low
    87 Historic 23 Front injector high
    88 Historic 32 Rear injector high
    89 Historic 16 Battery voltage low
    90 Historic 16 Battery voltage high
    91 Historic 43 VSS sensor low
    92 Historic 43 VSS sensor high
    93 Historic N/A Check engine light open/low NO CHECK ENGINE LAMP AT KEY ON or CHECK ENGINE LAMP ON CONTINUOUSLY
    94 Historic N/A Check engine light high NO CHECK ENGINE LAMP AT KEY ON
    95 Historic 35 Tachometer low
    96 Historic 35 Tachometer high
    97 Historic 25 Rear cylinder no combustion
    98 Historic 24 Front cylinder no combustion
    99 Historic 34 Loss of idle speed control
    100 Historic 35 Accelerometer fault
    101 Historic 34 Starter output high
    102 Historic 25 Ignition enable output high
    103 Historic 21 Left turn output fault
    104 Historic 22 Right turn output fault
    105 Historic 11 Battery voltage high
    106 Historic 31 Alarm output low
    107 Historic 32 Alarm output high
    108 Historic 41 Ignition switch open/low
     
    Last edited: Jun 27, 2007