Engine Light 2000 Ultra Classic

Discussion in 'Touring Models' started by stradwg, Jun 29, 2007.

  1. stradwg

    stradwg Member

    7
    11
    0
    Will Disconnecting Battery Cable Reset Engine Light
     
  2. glider

    glider Veteran Member

    25,464
    108
    43
    On the 2000 bikes , you usually have to have the dealer reset the light. It will also reset on it's own after 50 start and run cycles of at least 30 seconds each. If the light is lit and stays lit when you run, it is a current code for a fault that exists now. If it comes on at start up and goes out and then back on again, that is a historic code of something that happned in the past.

    Here's a way to check the code for why the light is lit.

    http://www.hdtalking.com/general_tips/729-00_03_hd_codes_and_activation.html
     
  3. stradwg

    stradwg Member

    7
    11
    0
    thanks.it does come on at start up and then goes off then back on.i have had a recent problem that has been corrected.
     
  4. glider

    glider Veteran Member

    25,464
    108
    43
    The dealer should have reset it for you when the job was done if they did it. Give them a shout and see if they can do it for you, it only takes a few minutes.