Do I have to change my mapping?

Discussion in 'Engine, Fuel and Exhaust' started by dan 09, Mar 21, 2009.

  1. dan 09

    dan 09 Member

    7
    11
    0
    I'm installing a 103 kit from H-D, and a Master Tune ECM. Question is, can I run the current mapping untill I can get to a dealership (who will set it up, and give me 3 pulls on the Dyno for $55), or do I need to set the tuner first, then reset it at H-D ?
     
  2. Bud White

    Bud White Well-Known Member Retired Moderators

    3,270
    48
    2
    i would think it would need to be set first and if so would tow it to dealer.. Glider probley knows for sure
     
  3. dan 09

    dan 09 Member

    7
    11
    0
    Yah, I was going to trailer it to H-D, but before they put it on the Dyno, they want 200 miles on the bike...not sure how to get the miles unless I trailer it to H-D, set the tuner, ride 200 mi., then have them reset again $$$. Any suggestions???