Cruise control brake light fuse blowing

Discussion in 'General Harley Davidson Topic' started by twicecam, Dec 27, 2008.

  1. twicecam

    twicecam Active Member

    241
    26
    0
    I'm trying to diagnose a problem on a 07 Ultra classic does anyone have any experience with the cruise /brake light/turnsignal, it keeps blowing the fuse
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
    Check under the rear fender and where the wiring harness goes from under the seat into the rear fender. Been a few that rubbed through the wires grounding them out.
     
  3. STEVE07

    STEVE07 Well-Known Member Staff Member Super Moderators

    4,033
    68
    41
    You can also check the connector into the cruise module mine wasn't locked in properly(my own fault) and when I would ride on a rough patch of road with the cruise on it would pop the fuse.:(
     
  4. okennon1

    okennon1 Member

    11
    11
    0
    Just for a quick reference check the elec couplings under the seat and behind the left cover. Sometimes in our over zealousness to wash every nook and cranny those gasket
    sealed couplings will leak a tad of H2O.
     
  5. whatyardwork

    whatyardwork Banned

    829
    0
    4
    Also take a look at the wireing to the throttle, Ive seen those get pinched after accessory installs.