Crossover Hose Clamps

Discussion in 'Engine, Fuel and Exhaust' started by stew, Jan 11, 2012.

  1. stew

    stew Member

    5
    0
    0
    Is there a trick to tightening the fuel tank crossover hose clamps or do I need the special pliers? Can I just use worm gear hose clamps instead? You guys are a big help, I've been lurking here and getting great info for some time. THANKS!
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
    You can use the regular worm gear clamps. If you use a set of end cutting pliers carefully, you can re tighten the stock clamps too.
     
  3. Bodeen

    Bodeen Well-Known Member Staff Member Moderator Contributor

    4,310
    73
    130
    You can use the worm gear type. Be sure to use the proper size so that they clamp properly.
     
  4. Jack Klarich

    Jack Klarich Expert Member

    18,544
    153
    399
  5. stew

    stew Member

    5
    0
    0
    THANKS! I'll pick up a couple worm gear clamps tomorrow and maybe finish this one hour job by day three!
     
  6. maine-e-axe

    maine-e-axe Junior Member

    732
    28
    1
    Thats where the newer 6 gallon tarks are nice, NO crossover line/hose:s