console insert ??

Discussion in 'Touring Models' started by ironmark, Mar 11, 2009.

  1. ironmark

    ironmark Junior Member

    754
    28
    4
    I just got a new console insert & I was wondering if there were any tips I should know about this proceedure , has anyone out there replaced the console insert before ? The only way that I can see to remove the old insert is with a small screwdriver wrapped in a rag .:newsmile04: & hope that I dont slip .
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
    Try some heat if it it glued on first, should come off with your fingernail under the edge.Not familiar with that dash.
     
  3. ironmark

    ironmark Junior Member

    754
    28
    4
    Well I found out that when you remove the old insert the only thing it is good for is the trash can . Removal is not to hard but it takes some time to remove the glue . But it is worth it IMO:bigsmiley12:
     
  4. dasscout

    dasscout Member

    6
    1
    0
    I'm about to takle this task on the weekend, is a hair dryer suitable for heating up the old insert? Any recommendation for removing the old glue?
     
  5. smkinnan

    smkinnan Active Member

    121
    18
    1
    definately, a hair dryer would probably be best...