Compensater stack up question

Discussion in 'Engine, Fuel and Exhaust' started by Benleakin, Jan 4, 2009.

  1. Benleakin

    Benleakin New Member

    3
    11
    0
    2002 fxdwg. Is my manual wrong? Book shows a hex spacer between sprocket and alternator cover. Their were no shims either. Chain measurements look good. Is Locktite primer needed when using 262.
     
  2. Benleakin

    Benleakin New Member

    3
    11
    0
    Thanks for the reply. The manual shows a hex spacer between the rotor and the shaft extension. My sprocket alignment was good before removing. Just making sure i didn't loose something. Their was no hex spacer or shims in the stack up.
     
    Last edited: Jan 4, 2009
  3. TQuentin1

    TQuentin1 Well-Known Member Staff Member Moderator

    4,633
    83
    100
  4. Benleakin

    Benleakin New Member

    3
    11
    0
    Yea , Doesn't look like it's been apart before. Was it left out at the factory? LIke I said chain alignment looked good before removed. Did I loose it?