clutch lever has no pressure

Discussion in 'Softail Models' started by Inferno Matt, Jan 18, 2010.

  1. Inferno Matt

    Inferno Matt New Member

    I have a 1340cc with an Ultima 3 1/2 primary drive. I had taken off the belt and cog and replaced my Clutch plates. Put everything back together. But have no pressure at the clutch lever now. How do I go about bleeding it or do I just need to screw the springs in further ? any help on this would be greatly appreciated. - Inferno Matt
  2. mnkymn1

    mnkymn1 Member

    Bleeding it? Is it a hydraulic clutch? If it's a mechanical one, check and make sure the balls didnt come dislodged from the ramp mechanism under the right side tranny cover.