Changing Cam

Discussion in 'Touring Models' started by dlingle61, Mar 14, 2012.

  1. dlingle61

    dlingle61 Member

    31
    16
    0
    Getting ready to change cams in my 08 96", Have seen a part list before but can't find it today.:wall Could someone please list parts needed. Thanks Dave
     
  2. BUBBIE

    BUBBIE Well-Known Member

    4,959
    83
    113
    Three "0" rings(one on the oil pump to sump suction hole, two in between the engine cam-plat. New snap-ring for front cam. Torrington engine side cage bearings to replace the INA's. Maybe a new gasket on the cam cover... (probably old will do just fine.)

    New harley Hydraulic lifters IF You feel the need... I still used my stock ones at 17,000 miles when I put in the SE255 cams in my 09 FLHR.

    SE SLENDER Taper adjustable pushrod set. (Best ones in my book)

    SE p-rods 24 thrds per inch, set them at No less than 3 full turn.:D

    ? maybe exhaust gaskets,,,, I have used mine several times with No Leaks.

    That is all I can think of.

    signed....BUBBIE
     
  3. dlingle61

    dlingle61 Member

    31
    16
    0
    Thanks for the info. Now just gotta get after it. Dave
     
  4. TQuentin1

    TQuentin1 Well-Known Member Staff Member Moderator

    4,633
    83
    101
    Check this out:

    Roller Chain Conversion white paper

    Harley Davidson Community

    TQ