Brake peg to high; mini foot boards temp solution

Discussion in 'Dyna Models' started by geislert, Jan 19, 2011.

  1. geislert

    geislert Banned

    1
    0
    0
    I have been having problems with foot placement on my Fat Bob brake peg since it sits a couple of inches higher then the gear shift peg and I am 6' 4". I found a temporary solution until I can figure out how to drop the entire assembly a couple of inches; the Kuryakyn Iso-Wing Mini Boards. They bolted right on and were rotatable so I could get the proper clearance to the controls.

    Anyone have a suggestion on dropping the entire brake and peg down?
     
  2. Brutal FXDX

    Brutal FXDX Active Member

    155
    28
    2
    Rear brake pedal has about 1/2" to 3/4" adjustment up and down. The adjuster is located back on the master cylinder for the rear brake. Just follow the linkage, you will find it. Hope it helps.