Big Sucker install help needed

Discussion in 'Sportster Models' started by gadzooks, Sep 16, 2008.

  1. gadzooks

    gadzooks Member

    50
    16
    0
    I received a Big Sucker air cleaner for my 04 Sporty, but the eBay seller didn't have instructions inside. Can anyone help out with install?

    There are four large bolts ... I'm guessing that they go into the engine ... but there are only two large washers. Is that right, and if so, on which bolts do they go on?

    There are two gaskets and one spacer. There was one sheet in the box -- a change in installation for 07 and later -- that explained the 07 and laters need the spacer. Do I not need the spacer for '04? Just one gasket?

    Where do these o-rings go? and there's a small tube of something ... loctite? lube?

    There's some smaller washers, too.

    Needless to say, this is a little frustrating and it's not the first problem that I've had with this seller.
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
  3. Bluesugar

    Bluesugar Member

    87
    16
    0
    Good info glider,as always!..This site has the greatest samaritans.
     
  4. glider

    glider Veteran Member

    25,464
    108
    44
    We try to be a cut above here:s
     
  5. gadzooks

    gadzooks Member

    50
    16
    0

    Brother Glider, you are awesome. I have not seen you stumped yet. Thank you very much. :D
     
  6. glider

    glider Veteran Member

    25,464
    108
    44
    Thanks, we try hard here to give everyone what they need.:D