Basic ignition wiring question.

Discussion in 'Electrical' started by neverdown, Aug 12, 2008.

  1. neverdown

    neverdown Member

    22
    11
    0
    To help me out, you need the Amen Chassisworks Wiring Diagram, found on this sit, I dont know where it is, though.

    On the diagram, it shows a starter button, which I don't have...I have an off-on-start key ignition.

    On the diagram, it shows the coil wire going to the start button, then to the relay which goes to the ignition, or "start". My Crane instructions say the coil wire goes to the on, or power position, so the module lights up when the power
    is turned on. This would be Accessories?

    As I dont have a start button, would I just wire the coil to the ACC, or to the relay which then goes to the Ignition post?

    Also, the diagram shows the starter grounded through the relay. As my starter ground runs to battery neg, do I still run a ground for the relay?

    Your help on this is appreciated. There does not seem to be anyone around here ( my town )that knows what-is-what. One guy even told me I dont need the relay, and just wire the green wire from the starter directlt to the ignition. But this does not supply enough power to the starter. I ordered the ignition booster relay from JP Cycle, to install, which would be the relay shown on the diagram?
    Thanks for any help.
    neverdown
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
    Last edited: Aug 12, 2008
  3. glider

    glider Veteran Member

    25,464
    108
    44
    Hope this simplifies it for you.:D
     
  4. neverdown

    neverdown Member

    22
    11
    0
    Re: Wiring Diagrams

    This one.
     

    Attached Files:

  5. neverdown

    neverdown Member

    22
    11
    0
    Yes, that helps, thanks!