adjusting push rods

Discussion in 'Engine, Fuel and Exhaust' started by kemo, Jun 26, 2009.

  1. kemo

    kemo R.I.P

    1,690
    48
    5
    I was reading an article on adj p/r. It said to measure the threads per inch and multiply by .6. My S/E p/r's are 24 tpi. X.6 = 14.4 flats. The recommended adj is 2 1/2 turns. Seems to me 14.4 would be tight. What do you think Glider
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
    You have to follow the manufacturers recommendations because of the threads per inch for their rods. When you don't that's where the problems start.