'94 FXR query

Discussion in 'New Member Introduction' started by Bernie Perth WA, May 10, 2014.

  1. Bernie Perth WA

    Bernie Perth WA New Member

    0
    0
    0
    Can anyone tell me the internal tread size of the timing sensor plate mounting bolts to which the outer cover is attached, looking through the '93 -'94 HD manual, they show that the outer cover plate is pop rivetted to the mounting bolts, is this the case or did HD change to cap bolts to fasten the outer plate on.
    If not then I'll drill and tap the mounting bolts to suit.
    If anyone can help it would be much appreciated.
    Regards,
    Bernie.
     
  2. tourbox

    tourbox Senior Member

    1,310
    68
    54
    I believe the screws are 8x32x1/2.It could also be a 10x24x1/2. I found those by looking at 1970 EG. They screw into the stud that holds the the timing plate(cam sensor) in the nose cone. When you use the screws they are at 3 & 9 o'clock,rivets were at 12 & 6. You will need to rotate the outer cover plate 90 deg. If you try to place the screws at 12&6 they will damage your cam sensor.
    tourbox
     
  3. fin_676

    fin_676 Experienced Member Staff Member Moderator Contributor

    5,277
    133
    156
    Welcome to the forum

    Brian
     
  4. Bodeen

    Bodeen Well-Known Member Staff Member Moderator Contributor

    4,310
    73
    130
    Glad to have you aboard! :ws:rider
    From Central Florida.
     
  5. tourbox

    tourbox Senior Member

    1,310
    68
    54
    Oh and by the way. Welcome from So. Texas.
    tourbox
     
  6. Joyflyin

    Joyflyin Experienced Member Staff Member Moderator

    5,324
    118
    93
    Welcome aboard, glad to have you here. :ws
     
  7. SledDog

    SledDog Senior Member Staff Member Moderator

    1,852
    58
    42
    Welcome!
     
  8. r_k_dragon

    r_k_dragon Active Member

    270
    0
    4
    Welcome to the forum from the southwest desert.
     
  9. STEVE07

    STEVE07 Well-Known Member Staff Member Super Moderators

    4,034
    68
    42
    Welcome to the forum. On my 93' FXRS they are 10-24 x1/2. Hope this helps