2011 fatbob wont start

Discussion in 'Electrical' started by jackjack, Jul 9, 2011.

  1. jackjack

    jackjack Member

    7
    0
    0
    fatbob cranks over but will not start,has no spark tssm had a code 61145
    i have a thundermax autotuner installed any ideas
     
  2. dbmg

    dbmg Experienced Member

    5,800
    153
    318
  3. jackjack

    jackjack Member

    7
    0
    0
    i wrote the code down as 61145 but when i looked up codes thought maybe it was a b1145,since then i have cleared codes,still wont start and have no new codes.i think it has something to do with security system not allowing ignition.my fob seemsto be working allright but i will go and try to enter manuall overide number

    entered manuall overide pin still will not start.looks like i will be re-fitting factory ecm to see if it will start then.
     
    Last edited by a moderator: Jul 9, 2011
  4. Iceman24

    Iceman24 Well-Known Member

    3,224
    48
    13
    Any other mods, other than the Thundermax?
     
  5. jackjack

    jackjack Member

    7
    0
    0
    just the usuall pipes,air cleaner
     
  6. Iceman24

    Iceman24 Well-Known Member

    3,224
    48
    13
    OK...getting good fuel? I'd say it's got to be something w/the tuner, or security...good battery in FOB?
     
  7. Hoople

    Hoople Account Removed

    7,198
    0
    34
    What do you see or what happens that makes you feel that way. (B1145 is transponder antenna loop is open)
     
  8. jackjack

    jackjack Member

    7
    0
    0
    std ecm made no differance,alarm pin overide made no differance,so its off to the dealer for warranty
     
  9. jackjack

    jackjack Member

    7
    0
    0
    It was the crank angle sensor only done 931km
     
  10. Hoople

    Hoople Account Removed

    7,198
    0
    34
    If it's not too much to ask, would you measure the bad sensor with an ohm meter. Would like to know if the resistance had a dramatic change. Also can you still feel magnetism on the tip of the bad sensor when it comes in contact with a piece of metal..