103 questions

Discussion in 'Touring Models' started by Tahoe Kid, Oct 8, 2012.

  1. Tahoe Kid

    Tahoe Kid Member

    14
    0
    0
    I have a 2007 CI 96 increased to 103. Not very happy with current numbers and performance, what can be done? Should have more????

    99hp/102tq should be more?

    HD 259E cams
    10.5/1 comp pistons
    HD 110+b heads
    50mm throttle body
    new fly wheel
    HD SE cam plate and oil pump
    HD screaming Eagle tuner
    Reinhart true duals

    Welcoming recommendations!

    Tahoe Kid
     
  2. BUBBIE

    BUBBIE Well-Known Member

    4,959
    83
    113
    What is your compression CCC, checked with spark plugs out. air opened (off) and butterfly open...

    This will tell something... Altitude you are from sea level taking the CCC?

    How many miles on that new motor?

    Who dyno truned it?

    signed....BUBBIE
     
  3. Jack Klarich

    Jack Klarich Expert Member

    18,544
    153
    399
    The thickness of the base gaskets and head gaskets can make a huge change in compression ratios, how does it run on pump gas any pinging?
     
  4. Tahoe Kid

    Tahoe Kid Member

    14
    0
    0
    Hey Bubbie- thanks for the reply..
    Live in Chicago area. Lower half-crank shaft, cams, cam plate and oil pump where installed 12K ago or so.. Jugs- pistons where cleaned, new rings, push rods and heads cleaned.

    Will get compression checked with out plugs.. couple of days.

    Kutter's in Janesville did the Dyno..

    Only burn 93 octane form Shell or BP no pinging..
     
  5. Jack Klarich

    Jack Klarich Expert Member

    18,544
    153
    399
    Ground the plug wires and pull the fuel pump fuse when you run the compression test, count the heat rings on the spark plugs just for grins then toss them, start with fresh plugs when you are done:s
     
  6. Hoople

    Hoople Account Removed

    7,198
    0
    34
    SEPST but what maps did you load? Custom, right off the software, individual dyno tested?
    Compensated for 103? The maps tie it all together.
     
  7. hogrotten

    hogrotten Junior Member

    636
    28
    2
    Sounnd like good numbers to me, I'm running a 106" kit with 583 S&S cams and I'm at 90HP 110FTLBS Torque with stock heads and intake.
     
  8. Hoople

    Hoople Account Removed

    7,198
    0
    34
    oops, just saw this..
     
  9. Hoople

    Hoople Account Removed

    7,198
    0
    34
    Actually I take that back. I just looked up Kutters. They are a HD dealership correct?
     
  10. Tahoe Kid

    Tahoe Kid Member

    14
    0
    0
    Wow, no one remondes a dealership?? Kinda aggree, sadley enough! So how do I locate a reputable guy to make the necessary mods??? Live near 60175 Saint Chalres, IL