07 Sportster code P0107

Discussion in 'Electrical' started by poobo, Aug 12, 2009.

  1. poobo

    poobo New Member

    1
    1
    0
    So I bought my first HD two weeks ago. A pretty 07 1200R with 5800 miles on it. Today (less than 200 miles later) the engine light came on. Code check indicates P0107 Map sensor open/ low EFI. Has anyone heard of a Map sensor failing at that low a milage? My auto mechanical experience indicates that sometimes Map sensor codes are other problems manifesting themselves as low/ high map indications ( at least on some cars). The (otherwise very nice) $60.00 genuine HD service manual does not give a test spec.( ohm test). Evidently you must buy the HD "electrical manual" for that type of info. Any help that you guys can provide would be greatly appreciated. This looks like a great site so I'm sure I will be spending countless hours here. Thanks!



















    efi
     
  2. glider

    glider Veteran Member

    25,464
    108
    44
    [FONT=verdana, geneva, helvetica]Sensor output voltage range is 0.5 to 4.5 volts.[/FONT] [FONT=verdana, geneva, helvetica]Output voltages between 0.5 and 1.5 volts indicate a high vacuum (low pressure) situation, such as idle or deceleration.[/FONT]
    [FONT=verdana, geneva, helvetica]Output voltages between 1.5 and 3.0 volts indicate a medium level of vacuum (pressure) such as a cruise or slight acceleration condition.[/FONT]
    [FONT=verdana, geneva, helvetica]Output voltages between 3.0 and 4.5 volts indicate a low vacuum (high pressure) situation such as hard acceleration or a mechanical failure.[/FONT]
    [FONT=verdana, geneva, helvetica]Any reading of 0 volts or over 4.5 volts indicates a problem.[/FONT]