03 fl passing lamps

[100ed]

on my 03 flhtc i need to tighten my passing lamps the only way i can see to tighten is remove the power wire from the passing lights . how did u get the wire from the conector ? thank you

 

[HDDon]

Harley sells a 3/8" drive socket with a slot cut in it so you can tighten the nut with the wires on. I made one using a 4" grinder with a cut off wheel, cut a 1/8 to 3/16 slot about 1" down. I will be down in the garage later and I'll get the size of the socket.

 

[100ed]

thank you the bolt is a 9/16 used my drummel to cut a hole in socket it worked again ty HDDon

 

[Jack Klarich]

Northern Industrial Crowfoot Wrenches Pc. Metric Set | Wrenches | Northern Tool + Equipment These are alot cheaper than the Snap on socket

 

[100ed]

thanks jack but because of tight fit it need to be a socket .my daughter works at a local hardware store so i picked 1 up from her to cut up .she also gets a discount that makes it cheaper .

 

[Jack Klarich]

Harley sells a 3/8" drive socket with a slot cut in it so you can tighten the nut with the wires on. I made one using a 4" grinder with a cut off wheel, cut a 1/8 to 3/16 slot about 1" down. I will be down in the garage later and I'll get the size of the socket.

Snap On toll is FRX181 9/16