outer primary

1990FXR

I NEED THE tightening sequence FOR THE OUTER PRIMARY A DIAGRAM WOULD HELP 1990 FXR

TQuentin1

On my bike ('91 FXDB-S) the book has you starting in about the middle of the primary cover on the two screws (top and bottom) that are just forward of the swell. Then you move in an alternating top-bottom X pattern forward and backward of that line formed by the first two you did. I like to start with by screwing the screws handy with the bit in a screw driver handle. Then I set the torque wrench at 65 in-lbs. and do the pattern. Then I increase the TW setting to 90 in-lbs. and do it again. Finish up with 110 in-lbs.

PRIMARY HOUSING - 1990 Harley Davidson FXR


TQ

__________________

Please stop by the "self help section" for maintenance tips, diagnostic codes and much more.
>>Self Help Information and Tips<< click me!

1990FXR

ok i read where if not done in the exact order it could warp the primary cover

glider

Usually it's a cris cross tightening sequence that is covered in the factory manual. Best bet is to get the manual if you are going to work on the bike yourself.

__________________
Psssst!
Please stop by the "self help section" for maintenance tips, diagnostic codes and much more.
click me!>>Self Help Information and Tips<< click me!

1990FXR

thanks thats what i needed thanks again