|
|
|
|
|
Hello Guest, Welcome to the HDTalking, registration is completely FREE and takes only a few seconds. By registering you'll gain: Full Posting Privileges, Access to Private Messaging, Optional Email Notification, Upload Photos, Upload Videos, Respond to Polls, Ability to Fully Participate. To register now click here! If you have any problems with the registration process or your account login, please submit ticket to our helpdesk team. |
|
|
3" open primary alignment tips neededClassic Models |
 |
|
|
Thread Tools | Display Modes |
Jul 9th, 2009, 07:01 PM
|
#1 |
|
New Family
Ride: 79 FXLR
Join Date: Jul 9th, 2009
Location: Wexford, Ireland
Posts: 2
 |
3" open primary alignment tips needed
Hi all
I'm having real trouble getting the belt to run straight on a Primo 3" open primary belt, has anybody got any tips? I've been at it for ages and its driving me nuts |
|
|
|
Jul 30th, 2009, 11:30 AM
|
#2 |
|
New Family
Ride: 1983 FXSB
Join Date: May 4th, 2008
Posts: 2
|
Re: 3" open primary alignment tips needed
Hi I have the same set up and how I did it was loosen the motor mounts make sure the tranny is also loose all 5 bolts take the mounting nuts off if you have too and then put the innet primary on and tighten her down. Then tighten the motor back down use a tork wrench and set to specs then tighten down all 5 tranny bolts to spec. Then I add 5 lbs to the wrench and retork the motor and tranny. Then take the bolts out of the primary and add blue lock tight and tork them to spec. Then take a straight edge and make sure you have the pulleys lined up most of the time it will take some machining for the front pulley to line up I had to take .025 off of mine. You could also get a different rotor that doesnt have that thick washer to suck it in closer but that is up to you. Good luck I know you will get her let me know if I can answer any other problems you may have. Ole
|
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
