|
Re: key fob problems
You can try disarming with pin following instructions below and see if the fob's start working afterwards?
POWER DISRUPTION AND CONFIGURING
The HFSM will not enter PIN entry mode on the first attempt
after battery voltage has been removed from terminal 1. This
will occur after any of the following:
●
Battery disconnect or power drain.
●
Battery fuse removal.
Therefore, after all battery reconnects, the configuration sequence must be modified as follows:
1. Set OFF/RUN switch to OFF , cycle ignition/headlamp switch IGNITION-OFF-IGNITION-OFF-IGNITION and press left turn signal switch twice.
2. Repeat steps listed above.
3. Continue with PIN entry sequence listed
__________________
Hollow Points - For Those Who Care Enough to Send the Very Best
|